Teltonika TRB141 industrielles, robustes, GPIO LTE-Gateway
Bildergalerie überspringen
slide 1
107,95 €*
% 127,00 €* (15% gespart)Sofort verfügbar, Lieferzeit: 1-3 Tage
Produktnummer:
TRB141003000
Produktinformationen "Teltonika TRB141 industrielles, robustes, GPIO LTE-Gateway"
Kleines industrielles LTE Cat 1-Gateway. Ausgestattet mit verschiedenen Inputs/Outputs und einem Micro-USB Port,
einschließlich Digital, Relay, Analog und Isolated. Perfekt für Anwendungsfälle,
in denen Geräte über I/O aus der Ferne verwaltet werden müssen.
| MOBILE |
|
| Mobile module | 4G (LTE) – Cat 1 up to 10 Mbps, 3G – Up to 42 Mbps, 2G – Up to 236.8 kbps |
| Status | Signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP, Bytes sent/received, connected band, IMSI, ICCID |
| SMS |
SMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP |
| USSD | Supports sending and reading Unstructured Supplementary Service Data messages |
| Black/White list | Operator black/white list |
| Multiple PDN | Possibility to use different PDNs for multiple network access and services |
| Band management | Band lock, Used band status display |
| APN | Auto APN |
| Bridge | Direct connection (bridge) between mobile ISP and device on LAN |
| Passthrough |
Router assigns its mobile WAN IP address to another device on LAN |
| NETWORK |
|
| Routing | Static routing |
| Network protocols | TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, SMNP, MQTT |
| VoIP passthrough support | H.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets |
| Connection monitoring | Ping Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection |
| Firewall | Port forward, traffic rules, custom rules |
| DHCP | Static and dynamic IP allocation, DHCP Relay |
| Network backup | Mobile, VRRP, Wired options, each of which can be used as an automatic Failover |
| SSHFS | Possibility to mount remote file system via SSH protocol |
| MODBUS TCP SLAVE |
|
| ID range | Respond to one ID in range [1;255] or any |
| Allow Remote Access | Allow access through WAN |
| Custom registers |
MODBUS TCP custom register block requests, which read/write to a file inside the router, and can be used to extend MODBUS TCP Slave functionality |
| MODBUS TCP MASTER |
|
| Supported functions | 01, 02, 03, 04, 05, 06, 15, 16 |
| Supported data formats |
8-bit: INT, UINT; 16-bit: INT, UINT (MSB or LSB first); 32-bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC) |
| DATA TO SERVER |
|
| Protocol |
HTTP(S), MQTT, Azure MQTT |
| MQTT GATEWAY |
|
| MQTT Gateway |
Allows sending commands and receiving data from MODBUS Master through MQTT broker |
| DNP3 |
|
| Supported modes |
TCP Master, DNP3 Outstation |
| SYSTEM CHARACTERISTICS |
|
| CPU | ARM Cortex-A7 1.2 GHz |
| RAM | 128 MB, DDR2 |
| FLASH storage |
512 MB, SPI Flash |
| INPUT / OUTPUT |
|
| Input | 2 x Digital inputs (configurable passive or active), 1 x Isolated input, 1 x Analog input ( with 4-20 mA capability). 1 x Configurable Inputs. Digital input 0 - 5 V detected as logic low, 8 - 30 V detected as logic high |
| Output | 2 x Relay outputs (latching and non latching). 1 x Configurable Output, Open collector output, max output 30 V, 300 mA |
| Events | Email, RMS, SMS |
| I/O juggler |
Allows to set certain I/O conditions to initiate event |
| POWER |
|
| Connector | 4-pin industrial DC power socket |
| Input voltage range | 9 – 30 VDC, reverse polarity protection; surge protection >31 VDC 10us max |
| Power consumption |
< 5 W |
| PHYSICAL INTERFACES |
|
| I/O’s | 3 x Digital Inputs, 1 x Analog input, 2 x Relays on 16 pin connector, 2 x I/O pins on 4 pin power connector |
| Status LEDs | 3 x connection type status LEDs, 5 x connection strength LEDs, 1 x Power LED |
| SIM | 1 x SIM slot (Mini SIM – 2FF), 1.8 V/3 V |
| Power | 1 x 4-pin power connector |
| 1-Wire | 1 x 1-Wire interface on 16 pin connector |
| Antennas | 1 x SMA for LTE |
| USB | 1 x Virtual network interface via micro USB |
| Reset |
Reboot/User default reset/Factory reset button |
| PHYSICAL SPECIFICATION |
|
| Casing material | Aluminium housing |
| Dimensions (W x H x D) | 74.5 x 25 x 64.4 mm |
| Weight | 136 g |
| Mounting options |
Bottom and sideways DIN rail, Flat surface |
| OPERATING ENVIRONMENT |
|
| Operating temperature | -40 °C to 75 °C |
| Operating humidity | 10% to 90% non-condensing |
| Ingress Protection Rating | IP30 |
| PACKAGE CONTAINS |
|
|
|
| Mobilfunkstandards: | 2G, 3G, 4G |
|---|
Anmelden
Produktgalerie überspringen
Zubehör
slide 1 to 5
%
APMON Erweiterte Überwachung der Partikelablagerung
20.900,00 €*
22.000,00 €*
(5% gespart)
APMON: Erweiterter Partikel Ablagerungswächter: Der APMON zählt in Echtzeit abgelagerte Partikelgrößen größer als 15 µm alle 5 Minuten.Der APMON liefert 24/7 Daten.Benutzerfreundliche Software bietet wertvolle Informationen in klarer Übersicht.Der APMON zählt und bestimmt die unbekannte Bedrohung Ihres Produkts.Der APMON überwacht den Einfluss Ihres Reinraumes auf Ihr Produkt.Geringe Kosten. Der APMON-Sensor ist ein holographisches Messinstrument.Die erfassten Daten werden in verschiedenen Bildschirmen angezeigt. Der APMON überwacht:Permanent das direkte Risiko einer ProduktkontaminationPartikel, die Ihr Produkt verunreinigen könnenDaten (Teilchengrößen und Abscheidemomente), um Ursachen der Partikelablagerung zu findenDie Zeit und Dauer in der des Produkts gefährdet istDie Auswirkungen der Nutzung Ihres Reinraums Inhalt Die APMON-Sensorbox enthält die folgenden Artikel:1x APMON Sensor1x Disposable witness cartridge1x 9 Vdc power Adapter2x APMON sensor batteries Der Koffer der Basiseinheit enthält die folgenden Artikel:1x APMON base unit1x 19 Vdc power adapter1x sensor cable1x remote access cable 1x user quide
Browan MerryIoT Hotspot Helium Miner V.1
400,00 €*
Datasheet Model Name : L0001Part number: 51B-200-0007R
